The end of the final length of exhaust pipe where it vents to open air, generally the only visible part of the exhaust system part on a vehicle, often ends with just a straight or angled cut, but may include a fancy tip. The tip is sometimes chromed. It is often of larger pipe than the rest of the exhaust system. This produces a final reduction in pressure and is sometimes used to enhance the appearance of the car.

Fitment

• Universal fit 2.5 Inch Inlet, Please Measure Your Pipe Diameter Before Purchase.
  

• The Compatible Just For Reference, Pls Measure Your Pipe's Dimension to Make Sure It Will Fit Before Purchasing

• Professional installation would be highly recommended
  

Features

• Protect the Original Tailpipe

Protect the original exhaust pipe from sun and rain to prevent rusting and deformation.

• Nice Looking

The black painting finish, elegant and mysterious, perfectly decorates the tailpipe of your car.

• Easy to Install

There is no need to replace any parts, No weld needed. No drill needed.

Installation

Step 1: Clean the surface of your tailpipe.

• Clean the dirt and sand on your tailpipe with penetrating oil and a shop rag.
• (Make sure your tailpipe is at room temperature, and do not clean the surface of the tailpipe after the car just went out)

Step 2: Slide the exhaust tip into your tailpipe.

• Try to slide the exhaust tip into the tailpipe. You may encounter some resistance, so use automotive grease to lubricate the pieces if necessary.
• Cover the end of the exhaust tip with a towel and tap it into a place with a rubber mallet.

Step 3: Fasten / weld the exhaust tip.

• Tighten screws and clamps to secure the exhaust tips. Should you worry that it is not tight enough, you can weld a joint between the edges of the tailpipe and the exhaust tip.
• Then, The Installation Is Complete.